V3.2.4.0 NEW Software Update (2022.11.04):
1.BMW EGS Change: Added 8HP(F) – Bench: (When connecting, it needs to be powered by the device)
（1）Read and write MAPS, read and write EEPROM, backup data, restore data functions
2.CAS Mileage Reset: add 9389115; fix 9287535、9395656
3.Fix some bugs and optimize software performance
How to Use CGDI BMW Programmer?
Run CGDI PROG BMW software after finish all connection
Go to FEM/BDC key match
The current FEM BDC needs update the ECU program before performing key matching. Please ensure that the car battery has enough power. The programming process, please keep the equipment cable connection
Please remove the FEM BDC and then use the programmer to read and save data from the 95XXX EEPROM chip on FEM BDC computer board
Read the original car EEPROM data file
The 95128 EEPROM chip
Wait for CGDI BMW reading chip data
Save data
Use the programmer to write the calculated new data to the 95XXX EEPROM chip , then put the FEM BDC back into the car
Write M95128
Check the FEM connection
Voltage test platform is on
Use the programmer to write the calculated new data to the 95XXX EEPROM chip , then put the FEM BDC back into the car
The ECU is being programmed…
Again, write M95128
Again, write M95128
Voltage test platform should be on
Please remove the FEM BDC and then use the CGDI programmer to write the original car EEPROM data back to 95XXX EEPROM chip and FEM BDC back into the car. Coding is successful!!!!
How to Update CGDI BMW Firmware and Software:
CGDI BMW Firmware and Software Update
Download links :